Dispensing unit for precise low volume dosage

The dosage module for the mzr-2505 (S/F), mzr-2905 (S/F) and mzr-4605 (S/F) pumps can be used for volumetric dosage of adhesives like UV cure adhesive, epoxy resin, screw fixing varnish, lubricants and silicon. The dosage module suits the dispensing of smallest amounts of liquids requiring highly precise handling  (small beads or spots) and the absence of afterrun. The liquid can be supplied from a 30 or 55 ml disposable cartridge which is directly connected to the pump. For liquids with higher viscosity, pressure of up to 5 bar may be applied to the cartridge. An air discharge screw enables to bleed the system  after cartridge exchange or to supply flushing liquid for cleaning. The dosing needles can be directly connected to the Luer-Lock male adapter of the pump. With the fixing bracket the module may be mounted onto the handling device.


  • High dosage precision
    precision CV <1% at low volumes
  • Exchangeable reservoir
    for cartridges 30 and 55 ml
  • Constant precision
    pump parts made of tungsten carbide
  • Broad viscosity range
    adhesives, oil, grease, polymers, gel
  • Compact dimensions
    120 x 60 x 200 mm (S/F-version: 117 x 69 x 237 mm), including controller and cartridge
  • Precision motor and sophisticated control
    DC-servomotor with integrated microcontroller
  • Dosage of small amounts
    discrete dosage and continuous delivery


  • Bead dispense
  • Filling technology
  • Assembly stations
  • Backfill of electronic components
  • Labeling
  • Oil dispensing
  • Adhesive dispensing
  • Grease dispensing
  • Silicon dispensing

Technical data

  • Smallest dosage volume
    0.25 - 2 * µl
  • Differential pressure range
    0 - 50 bar (725 psi) *
  • Initial pneumatic pressure
    0 - 5 bar (73 psi)
  • Viscosity range
    up to 50,000 * mPas
  • Precision CV
    < 1 % (Coefficient of variation CV)
  • Dosing needle connection
    Luer-Lock male
  • Cartridge connection
    Luer-Lock female
  • Wetted parts
    stainless steel 316L, Ni-based tungsten carbide,
    shaft seal: graphite-reinforced PTFE, PEEK, 316L;
    static seals: FPM, optional: FFPM, EPDM
  • Motor
    DC-servomotor, 24 V DC, 44 W
  • Interface
    0–10 V, RS-232, 1 digital input/output
  • Controller
    integrated 16-bit microcontroller with 7936 Bytes program memory for dosage tasks
  • Dimensions (L x W x H)
    120 x 64 x 230 mm (S/F-version: 117 x 69 x 237 mm)
  • Weight
    approx. 1,200 g
  • Remarks
    * depending on the size of the micro ring gear pump.
  • Notice
    Even if single parameters are within the indicated performance range of technical data, certain parameter combinations may not be achievable. Single parameters may exceed their indicated performance range under adequate circumstances. For detailed evaluation please contact HNP Mikrosysteme. Actual performance may vary. Specifications are subject to change without notice. 
    This document is subject to change without notice.

Show more


 Back to list